I want a speedo cluster for my EP82. I currently have the older speedo that doesn't work so I wud prefer to get a similar one to that. However, I can get access to the newer speedo cluster but it comes without the connectors and I would need those since my current speedo uses a different...
That is a possibility to make a custom exhaust manifold that flows twinscroll.
However, others have said that a twinscroll mani on the 4efte doesn't yield much different results because the engine displacement is so small and doesn't push as much exhaust to cause the twinscroll pulsing effect.
I recently got an IHI VF37 with the p25 (twinscroll) turbine housing. It came off 2006 JDM Subaru Legacy STI.
Has anybody here used this turbo on a 4efte?
Can u say at what rpm u got full boost?
How much power did u make with this turbo?
I got it dirt cheap in excellent condition...
I sold my EP82 2yrs ago (bought it modified so I didn't get the joy of building it) but now I've got me another EP82 with a completely stock setup. I plan to modify this car properly so your advice and experience is appreciated.
I need some advice on what size intercooler and piping to use...
I fitted a HBC Pro to my EP82 and my boost immediately went from 9psi to 14psi when I tested it. The boost controller was turned all the way down (meaning should not be adding any boost), yet this happened. Also, my mech said everything was connected the way it should be per the diagrams in the...
I have experienced this twine in a year...the boxer engine sound is a little cool until you realize you got no power. Best advice if you running boost is to get a good tune.
I mean something that won't push out past the bumber too much, won't be loud and won't point down.
This would be ideal I suppose but currently not something I have access to and would cost me a pretty penny if I imported.
I would be looking for the quiet note and I would like that stock look. I guess i'll just go with the bottom one and see how that works out. I had on the HKS Super Dragger II but when i changed my turbo, i had to do over my exhaust work. Ended up giving the HKS to a friend and trying to get a...
Need some advice in regards to which muffler would fit best on an EP82.
This one has a 3" inlet and 17" in total body length (Vibrant TPV Turbo Muffler part#1062)
This one has a 3" inlet and 20" in total body length (Vibrant Flat Black Muffler part number 1147)
I need to get some plug wires and a distributor cap. Its a 5e engine and the cap i had on is the one without clips (the plug wires just slide on). I've been trying to get genuine plug iwires but can't find any.
Which plug wires do you guys suggest if i can't get genuine? Also, other than...
Since no responses to my question and i wasn't able to find a smallr (9.8t) backhousing, I have fitted the 10.5t. Hopefully it will yield positive results or I am back to square one.
I need some information on using either of the above sets in my 5e engine. Which set is better for my engine (not planning on more than 250hp daily driver)? Which set is easier to get?
I got a TD05HRA 16g6 10.5t but now i'm being told it may be too big for my 5e to spool. i had on a TD05 from the EVO III and that spooled fine. I know this turbo is bigger but i need to confirm whether its gonna be good on my car. One suggestion i got was to get a smaller back housing but i...
I got 5efe, TD05, greddy blue (running rich - needs a retune), 440cc injectors, walbro 255lph pump, recently installed a MSD coil.
I don't think its the Greddy even though it needs to be retuned. I think it's electrical but i may be wrong.