Search results

As above whats the approx weight of a 4E-FTE??

hi folks is the above possible

Looking for an outer CV joint for the passenger side of my Glanza. The car is a 99 Ep91 (auto with manual converstion) can anyone tell me which CV Joint i need as i believe there are different amounts of splines ???

Hi folks, the glanzas started making a rattling/knocking noise when the steering is just about on full lock turning right, is this the CV joint needing replaced or the drive shaft?? Where is the best place to purchase the above and is it an easy replaement?? Cheers

Help folks, just put the turbo and a few things back on the car and when i started it there was oil spewing out over the top of the turbo oil pipe (silicone 90 degree pipe) under turbo, Why might this be? It is a spring clip on the pipe should it be a jubilee? Also i replaced the original...

Right folks wheres the cheapest place to buy the above for the CT9?? Is £35 about right?

Hi folks, has anybody fitted the above to an EP91? If so how does it look and what suspension etc are you using?

Been looking for a drivers side rail for my recaro SR3 seat, does anybody know if the Bride RO-Type (EP91 Specific) will doe the job, if not does anybody know a rail that will? Cheers Folks

Right folks i have to own up, i've been stupid. Went to replace my rocker cover tonight (job i've done god knows how much times with no problems) anyway i was tightening up the nuts when CRACK i notice a split in the cam cover :(. So after undoing all the nut i find that the threaded rod has...

Hi folks just wondered if anybody knows how to contact James from CJ Performance?

Right folks i am running a CT9 and am away to port the wastegate. I want to relocate the air filter but am struggling to fit the new piping between the oil filter etc etc. Do i need to relocate the oil folter to relocate the air filter??

As above, i have been getting a weird noise from the rear of my Glanza for the last while, i can only describe it as a boomerang wooshing noise. I have done a good bit of detective work to try and fix the problem. i've replaced the rear discs and pads, both rear wheel bearings and checked...

Got a old exhaust manifold, i want to skim the mani to block flange, how much should i take off ?

Want to run this setup on stock internals, is there anything else i need to run safe with no fuel cut etc? Standard CT9 Turbo Filter Relocated Upgraded Exhaust Mani Decat Pipe Blitz Nur Spec Exhaust system RRFPR Boost Controller Wideband Walbro Fuel Pump Any info would be great

Hi there, where is the best place to buy the 90degree oil pipe/hose for a ct9 turbo?

Right folks, just wanted to clear a few things up. I am thinking about going TD04 soon(as most folk do) but i am thinking about going for a TD04 Hybrid. What i wanted to know is, I have been told that a TD04 can be run on a standard engine safely at 1Bar, is this tne same with the TD04...

Hi folks, as above my V dosn't seem to be pulling as well as it used to, havent made much changes recently but just seems a bit bogged down. The turbo is boosting and holding boost great. Any ideas what it mite be??

As above folks, is UKSC (UK Starlet Club) dead? I was aware there was a few issues a while back but i am having trouble to get onto the forum/site. Anybody know whats happening?

Hi folks, looking for a decent CT9 hybrid thats pritty much ready to go on the car, if anybody has something gimme a txt on 07724177665 cheers

Hi folks Looking for a part number for EBC greenstuff pads for the front of my 99 glanza V with ABS anybody know this and where is the cheapest place to buy ???