Search results

If you need any odds and sods of joiners and piping drop me a message. I have various bends and reducers that I have been hoarding.

Buying individual bends and joiners gets expensive but sometimes its the only way. I think the most cost effective way is to buy a CT9 kit then modify it to your needs as an when. T bolt clamps work well but some of the cheaper ones fall apart when the salt gets in even though they are all...

Just about to fit a magna flow sports Cat for MOT reasons. Does anyone know if it matters whether my wide band sensor is before or after the Cat?

AN is not metric you need AN -8 hose for AN -8 fitting and so on. There are also a few different types of AN fitting that require matching type hoses. I ve been using the torque AN fittings and hoses from there ebay shop and not had any issues. My advice is to buy the hoses from the same shop...

Does the pump continue to run or is it residual pressure in the system? Having the pump run only when the alternator is charging is more important to me as I only have a small race battery and my car is not a daily drive. I do have a timing relay and I could wire something up using a normally...

Yeah that's what happens in all power steering systems electrical or belt.

Aanyone know where the choke heater is?

It needs to run after the engine has started or it will put to much load on the battery.

Thanks mate just got to work out where to tap it off and which wire it is.

I am looking for a live to switch a relay to power an electric power steering pump. I need the pump to come on after the engine is running. Thanks in advance. Peter

Ok thanks mate.

Due to some unforseen circumstances I now have one orange indicator and one clear. So bought a clear one and went to change the lenses but the seal has disintegrated after cleaning. Where can I get a new one?

Anyone got a JAM racing FCD going spare? Cash waiting.

Has anyone fitted a saxo power steering pump and if so what is the thread on the female connection for the supply? on the pump that is Peter.

So I have finally started to finish of my EP95 that I started 7 years ago (build thread to follow) but due to being a little bit more grown up and having a wife kids and a house I cant get away with spending as much as I used to. So my question is when it comes to gauges do they all need to be...

As above any type Thanks in advance Peter

As above for delivery

As above cheers in advance.

Thanks mate.

Need to setup the ride height on my ep95. should the front and rear coilovers be adjusted to the same exactly the same height on the actual coilover?