Search results

yea thank god, this site is great lads keep up the good work, yea ill get a good job done, hopefully at the weekend. im not driving it at the mo anyway.

jesus this seems a pure balls,espically after replacing everything, it seems the battery isint holding the charge, whats your battery connections like? are they good and tight? any corrosion? it seems its something simple.

seriously lads thanks a million for the info it has been annoying me an i appreicate it alot, and the pervious owner didnt have a clue, ive saved this car from another scrap yard:rockon:

ok so that spade connector should fit on to the end were the actual sensor is? i have a few family memebers that are sparks. thanks.

ahhhhh flippppp!!!!! lol yea its thick enough wire, right so where do i go from here can you buy the wire and conector from toyota and i can get it solderd on?

lads just a quick question before i go out and pul everything apart.... is the knock sensor wire blue? as i have a sniped blue wire on the injector loom. thanks!!

yea as said above there exhaust systems are good quality and there front mounts would be dead on i belive there exhaust systems are the same as the japspeed ones on camskill which is the one i bought, i also have the manifold i got mine 2nd hand and had to get a weld done, it cost 20e to get the...

yes john thanks for the info, i dont think i have the wire im going to have to have a good look tomorrow as i did a sort of wire tuck on the injector loom. i put it across the inlet mani.

camskill is a great site. was just going to say try them

ok so i know the ep82 is throwing up the knock sensor, i heard that its on the back of the block, under the intake manifold, so after a few minutes of routing around i think ive found it! so what i can tell by feel its a big nut, but by god its akward to get the hand in so would that be the...

good man thanks:rockon:

can someone show me where the knock sensor is as im having the same problem, i havent replaced anything yet. BALLS!

well it is the knock sensor:(:( ive had no experience with these before, will it be the senor itself? higly unlikely im guessing, heres the deal the car has 2 different set of plugs and leads on the car, would this cause knock sensor to go of? i havent got around to replacing them as im not...

thanks a mill lads, ill get those parts of toyota and some tiger seal. thanks again

bump? lads whats the common fauts with this?

yea some of the clips are broke ya see, plus the new door didnt have the bracket that runs along the bottom for the plastic to bolt on to. that last one rusted away unfortunatly, so tiger seal it all round?? just plaster it on all over the plastic? give the pieces a good clean up first? and...

right lads my drivers door was replaced but whats the best thing to use to stick the plastic on to the door??

howl on a minute lads, what does this mean, wht would cause this to go of?? ive had the car 6 months now but i havent been driving it, i just go out and start it etc and have had someone take it a run for me, i dont hear any knocking coming from the engine.

just wondering would anyone know what it could be? i thought it was an O2 sensor im not sure though the car seems fine other wise, whats the best way to bridge the connections on diagnostics thing?

fantastic thread keep up the good work. :)