Search results

Any one care to help me out?

Hi guys I need help about how good is the Gt28 turbo that comes off a Nissan ser20det black top engine, the part number on the turbo is XA 1196J , 14411-69F00 , 466541-3001 its a Garrett ball bearing turbo, Currently I'm running the TD04L which is awesome on my forged 4efte but the...

I bought a TD04l mild steel branch from toyosports and it cracked so bad in just under 1 month, I would not recommend their branches, best u get 1 made up with a 3mm wall thickness unlike the thin wall thickness crappy branch toyosport sells. That's just my experience

I thought as much it had something to do with that, where can I get a step by step guide on how to disassemble and assemble the 4e geabox? Also what's the best gear ratios for the 4efte engine with the TD04l turbo, I installed wiseco forge pistons and scat rods, arp bolts top to bottom,athena...

I'm from south Africa and not many 4efte mods done here, I'm running a fully forged engine with TD04l and had my 2e 5 speed gearbox mated to my engine the problem is the 2e geax broke only on the diff section. I managed to get another gearbox from a guy I know from zimbabwe and he told me he...

which way does the athena metal head gasket fit? i have done that but i noticed there is oil seeping out through the side of the head and block, i thought it was oil leaking from the tappid cover seal but it's not, could it be i put the head gasket on the wrong way? the way i put it on...

thanks alot man

thanks man, i did torque it to 60ft/lbs but does it matter to torque it more tighter when using a metal head gasket?

i doubt thats correct because im using standard stretch head bolts, im using arp head bolts. i just want to know if anyone used the 1.2mm athena metal head gasket and what did they torque the arp head bolts to?

hi guys about the athena metal head gasket 1.2mm from tm development, using the arp head bolts does anyone here know if the arp bolts should be torqued more tight? i torqued mine to 83nm but it seems like there is oil seeping between the head and block. i just recently built up a forged...

hi guys does anyone know what size is the induction pipe for the td04l turbo?

thanks for the help guys but does anyone know what the bore diameter measures up to after the rebore and special clearence? im sure some one must have done the same forge kit conversion and should know what the bore diameter measures up to after the special clearance is done so i can compare...

hi guys i recently did a 74.5mm forge kit on my 4efte engine and i installed a new td04l turbo but the engine was smoking so took the head off and seen that all 4 pistons had oil on it. it seems like there was oil passing by the rings, i sent the block with the pistons to the mech and he said...