4efte standard timing

[dac69er]

Hi! Its very nice working table! Thanks to you and the creator of these table!
Is there also a power fc target lamda-fuel table at your disposal?

There is, I can upload this tomorrow. However, the power FC does the fuelling a bit strangely. It is the function of both a target afr map and a correction map.

As long as you bear that in mind, then you will be fine.

 

[Romaryo]

However, the power FC does the fuelling a bit strangely.

Do you feel any inconvenience: increased fuel consumption, overheating, unhealthy loud sound, vibrations, is it possible to travel for many hours on the autobahn?

 

[dac69er]

these are the injector and base maps from the power FC for 4efte.

in short; the injector map can be set to be a target AFR or a correction map. the base map is msec injector opening.

 

[dac69er]

Do you feel any inconvenience: increased fuel consumption, overheating, unhealthy loud sound, vibrations, is it possible to travel for many hours on the autobahn?

with these settings, it runs fine. its just a bit flat power wise.

i wouldnt want to run it long term without getting remapped. it may be ok, but it i wouldnt want to chance it without it being checked.

 

[Romaryo]

However, the power FC does the fuelling a bit strangely.

its just a bit flat power wise. i wouldnt want to run it long term without getting remapped. it may be ok, but it i wouldnt want to chance it without it being checked.

Man, thank you so much! Сould you describe in more detail what we should focus on?

 

[dac69er]

Man, thank you so much! Сould you describe in more detail what we should focus on?

I am not a mapper so I wouldn't want to say. You just need to check the fuelling is correct for the load of the engine and make sure you aren't getting any knocking (preignition) from advanced timing.