Another fuel injector conversion question

[TheStarletGT]

I have a Microtech LTS8 ecu, running to my knowledge standard injectors. Now if i want to run 7MGTE or 3SGTE injectors, can it be a direct swap, and my ecu will work perfectly, or is there a risk.

RE: Low/High impedance injectors etc. Would i need a resistor for each injector.

Are the two types of injectors above low or high impedance injectors.

 

[chinesemafia]

check this out friend

http://www.toyotagtturbo.com/forums/showthread.php?58024-Interchangelable-Injectors-*

 

[TheStarletGT]

I cant recolect a fixed location in this forum about the flow rate of a standard starlet gt injector. Is it 330cc, i just need clarification as reference to what i need to upgrade to. I recon 380-400 is plenty for an upgrade

I have checked my injectors and their high impedance, 15.3 ohms each.

 

[HYBRID]

the lt-8 can use both low or high impedance injectors, it just depends on which i/j drivers you have loaded... the oem injectors are 295cc, with an impedance of 13.9ohms...

kon

 

[Rev]

As Kon said 295cc but
www.williams.co.tt/s15/inj_top-en.htm list oem ep82 injector part no. ND 23250-11060 as 295cc with resistance at 14.8 Omega. Interestingly the following flow rates are given for the 295cc Injector -

Static flow rate/min 290cc @ 2.55bar [ 0.90ms Invalid injection time ( ic$4v) ]
Static flow rate/min 320cc @ 3.05bar [ 0.91ms Invalid injection time ( ic$4v) ]
Static flow rate/min 345cc @ 3.55bar [ 0.93ms Invalid injection time ( ic$4v) ]