Anyone know how to get a 5e Td04 to pass emissions ??

Jay

Admin
What readings are you getting?

Most setups I've seen have been fine at test conditions. So long as you aren't pumping an obscene amount of fuel into the map at idle it should be fine. If in any doubt get you emissions checked prior to the test.
 

5e colin

Member +
that mani is the so called shitty toyosport mani :) :) but this is the gen1 mild steel version there great you only knead to make the plate from vf/td to ct9 cat

and a small trim where the gearbox bolt is !! also bit of alignment kneaded when making the plate to make sure the exhaust angle is right

i didnt take this in acount the first time so this is plate nr2 :(

passed emissions. it dont matter if its 4e or 5e
 

bongskag

Member +
Just looking to find out if anyone knows how to pass the NCT/MOT on emissions with the 5e Td04 :confused:du
what year is is mate ? I book mine in as a non cat test .. although I think 6/1994 is the cutoff date for the non-cat tests ..
cant you get him to put the probe up another exhaust ( I.e a different car ;) )

did you fail the test already ? if so please post the results too ,
 

superstarlet96

Fresh Recruit
that mani is the so called shitty toyosport mani :) :) but this is the gen1 mild steel version there great you only knead to make the plate from vf/td to ct9 cat

and a small trim where the gearbox bolt is !! also bit of alignment kneaded when making the plate to make sure the exhaust angle is right

i didnt take this in acount the first time so this is plate nr2 :(

passed emissions. it dont matter if its 4e or 5e


Perfect Colin that sounds like a task I'm going to give it a go I think I was talking to you before on toyotaownersirl :rockon: do you know where I would get good pistons and rods for the 5e engine reasonably priced but no shit :homer:
 

5e colin

Member +
@ bongskag . cut of is the last day off 1993 here in ireland

@ superstarlet > probly i get pmed allot of questions :)
 
Last edited:
Top