Apexi avcr

[BoostJunkie]

right guys found a useful setup guide for the avcr on here never set one up before, http://www.toyotagtturbo.com/forums/showthread.php?t=1181

but my problem is i've just rebuilt my gt and cant set the boost on it correctly as it says how to ^,because obviously it aint been run in yet is there a setting on the avcr i can set it to say standard .7,-,.8 so it can be driven safely before it gets ran in and mapped ?

i'm running a turbosmart ext gate which has a 7psi standard wastegate spring.

cheers colin

 

[After-Glanza]

If u run with the boost controller off it will run at the wastegate pressure so u cud just do that until it's run in and then set up the controller.

 

[Sparky]

What after glanza said, theres two settings on there or OFF which will then just run at the wastegate pressure

 

[jam]

hello mine when off its going crazy I set 1bar when turn on its stays 1bar but when i switch it off it goes 1.2bar am using Tial 35mm ex.w.gate with .4bar spring.

 

[BoostJunkie]

If u run with the boost controller off it will run at the wastegate pressure so u cud just do that until it's run in and then set up the controller.

cheers a/g and sparky that was my thinking aswell was just wanting to make sure