ar wont start unless i unplug map sensr? help

[Gryzor]

called over to chris this evening and plug the emu in and the car started,
but after moving the emu it cut ...looks like a bad connection on the rpm.
Opened the emu box and the pcb looked like some water had condensed on the pcb causing the problem.

worth keeping your emu out of the car if your leaving them up for a bit.

Mines up and running again but v lucky

maybe worth a spell in the hot press goldenvtr?

 

[goldenvtr]

cool. random problem you had lol, being as though i only have 1 emanage for 2 cars (lol) ive had it in use.
if i plug it back in my mazda and for some reason i have the same issue then i know the emnagae is at fault. but its not quite ready either yet.

got 3 cars and none of them are on the road! hha

 

[Gryzor]

Ok just a quick update the emu stopped working again, so this evening I opened the box and a chip fell off the board,,
Resoldered it and the emu is back working. The chip in question was on the edge of the pcb and probably pushed off the board by the case.

 

[Sheldon]

Ok just a quick update the emu stopped working again, so this evening I opened the box and a chip fell off the board,,
Resoldered it and the emu is back working. The chip in question was on the edge of the pcb and probably pushed off the board by the case.

thats the ignition chip mate. and yes.. came off cos of the case for sure.