glanza/001
Fresh Recruit
hi all iam new to the site and would like some info on fitting a bleed valve.
i have already done the pipe switch to disable the hi/low boost.
when reading up on fitting a bleed valve it states if the actuator has more than one port one port needs to be blocked off.i have traced the second port up to the pipe which leads over to the pipe i have swiched.
is this ok to go ahead to fit the bleed valve or do i need to block it off?
thanks for any help.
i have already done the pipe switch to disable the hi/low boost.
when reading up on fitting a bleed valve it states if the actuator has more than one port one port needs to be blocked off.i have traced the second port up to the pipe which leads over to the pipe i have swiched.
is this ok to go ahead to fit the bleed valve or do i need to block it off?
thanks for any help.