Clutch release bearing???

dac69er

Super Moderator
Are they all the same between stock clutches and uprated clutches? (Ignoring any special twin plate ones etc)

I have a 3 puk exedy paddle clutch and want to stick a new release bearing in whilst the box is off. I didn't want to put a stock one on and it disintegrates after 5 minutes!

Thanks
 

Jay

Admin
Don't recall using anything special on the upgraded clutches in the past. Think the OS Giken had a fancified unit but that's all that springs to mind.

As you already know stick to genuine Toyota or a brand you trust.
 

dac69er

Super Moderator
They all physically look the same, just wondered if there was any subtle differences to cope with the stronger pressure plates or anything.

Tbh, the current bearing is fine and has probably only done a couple of thousand miles anyway. As the ep85 box is a bit of a pain to remove I feel I should change it.......!
 
  • Like
Reactions: Jay
Top