rage
Lifer
I had all my gauges sitting on top of my dash and it was less than ideal to say the least. so i decided to try and make a new custom center console to house my gauges in (stripped out a few non essentials like double din and heater vents)
Stripped out an old console, left the sides intact along with the 4 mounting points.
Been tinkering with a few tubes to find the correct angle to put the gauges in
Strap a piece of an old pantyhose over that and the rough form starts to show itself
drenched in resin
Placed the heater controls etc in their new spot
after that i could play with the filler
and sanding... sanding.. sanding.. more filler, sanding, sanding, (plenty of hours of filling and sanding)
Needs a few more layers and a lot more sanding but it's taking shape!
Spraying
And the end result!
quite pleased with this one, much much better than the previous one
Stripped out an old console, left the sides intact along with the 4 mounting points.
Been tinkering with a few tubes to find the correct angle to put the gauges in
Strap a piece of an old pantyhose over that and the rough form starts to show itself
drenched in resin
Placed the heater controls etc in their new spot
after that i could play with the filler
and sanding... sanding.. sanding.. more filler, sanding, sanding, (plenty of hours of filling and sanding)
Needs a few more layers and a lot more sanding but it's taking shape!
Spraying
And the end result!
quite pleased with this one, much much better than the previous one