Greddy type S, Strip and clean (Guide)

quadcorecraig

Member +
Here is my guide!

BOV type: greddy type S (GEN)

Tools needed:tiny alan key, rag, gloves is your keeping your hands clean (pussys)

Other bits: Rag, meguiars all metal polish, autosol

Time: 35min

Get started.

dirty grime stick to the BOV
P1040842.jpg


P1040843.jpg


P1040844.jpg


you need to undo the 6 alan key bolts that holds the head of the bov to the cylinder

P1040846.jpg


make sure you keep your hand down firm to stop the spring from flying off into the air and you not being able to find it again
also to undo side to side (slack each bolt first)

P1040847.jpg


remove the top

P1040848.jpg


remove the spring

P1040858.jpg


pull out the piston dont tear the lining

P1040853.jpg


P1040849.jpg


start your polish , i am only hanf poilishing it just to clean it up abit am sure there people who could get it brighter this will do for now

P1040850.jpg


P1040854.jpg


P1040855.jpg


pop the pistion back in

P1040856.jpg


P1040857.jpg


spring back on

P1040858.jpg


clean out any grime inside the top hat

P1040859.jpg


clean the screws cuz lets face it you wount stick your dirty dick in a fresh clean bird would ya?

P1040860.jpg


screw back down holding the hat flat and screwing back down side to side

sorted

P1040861.jpg


P1040862.jpg


P1040864.jpg


P1040865.jpg


^_^

reps always good :]
 
Top