Hi
I have bought a Platinium Sport 1000 for my glanza
Have just finished the wiring. We are however getting an issue concerning the injectors which we think are not opening. We wired injectors 1 & 3 to Haltech injector output 1 and injectors 2 & 4 to Haltech
Injector output 2, since we are using batch injection as we selected in the software. The Toyota OEM also uses batch injection. We even tried it in sequential but to no avail.
We are however getting +12 volts out of pin26 (ecu injector power) from the 34 pin plug. We are also getting no signal out of the Haltech injector output.
We would like to know if this 12v from pin 26 is normal.
Below is link to haltech ps 1000 wiring diagram ;
http://www.haltech.com/wp-content/uploads/2011/01/Platinum1000WiringDiagramrevJ.pdf
thanks
I have bought a Platinium Sport 1000 for my glanza
Have just finished the wiring. We are however getting an issue concerning the injectors which we think are not opening. We wired injectors 1 & 3 to Haltech injector output 1 and injectors 2 & 4 to Haltech
Injector output 2, since we are using batch injection as we selected in the software. The Toyota OEM also uses batch injection. We even tried it in sequential but to no avail.
We are however getting +12 volts out of pin26 (ecu injector power) from the 34 pin plug. We are also getting no signal out of the Haltech injector output.
We would like to know if this 12v from pin 26 is normal.
Below is link to haltech ps 1000 wiring diagram ;
http://www.haltech.com/wp-content/uploads/2011/01/Platinum1000WiringDiagramrevJ.pdf
thanks