no engine management light

[StarletNutter]

yeah getting power to the pump,checked it with a multi meter yesterday,even tried a new pump,its just not pumping,
loom was always like that,when I striped it back it was a mess,but got everything joined back up in its rite place,copied an old loom a mate had,

 

[5e colin]

bypas the car loom and put a strait fused wire to the battery and open the feul line on the rail shuv line in bottle and then connect the fused wire to the + of the battery to see if its pumping u might have a draw on the system

when nothing comes out this way then ur pump is fekkerd

are u getting spark

 

[StarletNutter]

just ran a wire to pump and she pumping

checked for spark and not getting any

where do I go from here

 

[5e colin]

just a stupid question but do u have immobiliser? on the gt

u are going to have to test ur mains relays efi etc

burnt out ecu ???????????????

 

[StarletNutter]

no imboliser,
will do man

 

[StarletNutter]

got new ecu
and tried all new fuses and relays,main,efi

still no joy

 

[5e colin]

burn it

jesus u must have burnt out something keep looking best of luck allan

 

[triple j]

Well man i never got any time free yet, i can give u a shout up during the week for a look, in the mean time i would check for continuity between these things.

 

[StarletNutter]

sound lad,ah lost interest in it at it all weekend trying to find problem,auto electricians just up the road,bringing it to him after work tomorrow,can't be arsed routing anymore lol

 

[5e colin]

let us know what the problem was in the end

 

[triple j]

let us know what the problem was in the end

X2 lad let us no the crack.

 

[StarletNutter]

took the whole loom out last nite checked it over with another one,all wires fine,something told of to take out the fuse board inside the car took it apart to find it all melted inside,got another one last nite just to refit the loom and fuse board,hope it solves it,good man Colin should of checked it before I took out the loom lol

 

[5e colin]

ha ha ha now u know ha ha ha it aint fun is it ( still laughing ha ha ha )

back on top why did it melt ? because it can happen again

 

[triple j]

good to here man, could of melted over the bad wires that u tidied up.

 

[StarletNutter]

don't know Colin,I just tided up the whole loom re taped everything up and no lose wires any more,shouldn't happen again,rebuilding my engine now,have it all striped,sending the head of to get a skim and a few other bits to order to

 

[GT-TD04]

don't know Colin,I just tided up the whole loom re taped everything up and no lose wires any more,shouldn't happen again,rebuilding my engine now,have it all striped,sending the head of to get a skim and a few other bits to order to

Glad you got sorted, I was offline for the last month, just got the internet back in today.

Solder, shrinkwrap and tape if you can. Might not stop at the fuse box next time.

What happened the engine?

 

[StarletNutter]

don't know what caused it,must of been the lose wires in the bay hit off the body or something she all taped up and checked all wires for brakes and dodgy connections,ah the head was on its way out man she was using a bit off water,took it off last nite and a wee bit off the gasket was fuckd at cylinder 2,should have it finished buy the end off next week