Starter Motor

Jay

Admin
Lie underneath and disconnect the plug connector and earth strap nut.

Remove the two 14mm holding bolts from above.

Slide back under and maneuver the loose motor out carefully.

Fitting is just the reverse, bit fiddly but straight forward.

Not sure on the one in that link as I've never used them but it looks correct. There's a few different types (stronger version in the Snow Versions) but the fitment and connections are the same.
 

Fizturbo

Member +
Bought this 2 year ago cost £68 after exchange
 

Attachments

  • Screenshot_20210502-113707_Gallery.jpg
    Screenshot_20210502-113707_Gallery.jpg
    96.3 KB · Views: 2
  • Screenshot_20210502-113557_Gallery.jpg
    Screenshot_20210502-113557_Gallery.jpg
    135 KB · Views: 2

Djaniero

Member +
Lie underneath and disconnect the plug connector and earth strap nut.

Remove the two 14mm holding bolts from above.

Slide back under and maneuver the loose motor out carefully.

Fitting is just the reverse, bit fiddly but straight forward.

Not sure on the one in that link as I've never used them but it looks correct. There's a few different types (stronger version in the Snow Versions) but the fitment and connections are the same.

Legend. Thanks a lot Jay.
She's going in for a remap on Wednesday - Hope she survives lol - but I'll get on the case and remove it afterwards.

Bought this 2 year ago cost £68 after exchange

Thanks Fiz. Theres a local place that I've used before to recon my alternator, so could be an idea just to do that instead.
 
Top