TD04L on 4EFTE must be rotaded? And other questions...

Z

zero_2k3

Member +
Hi my name is alex. I'm from Germany and i have any questions about the 4EFTE. I'm build at my forged 4EFTE. I want fit a TD04L on it, 8.2 compression ross/wiseco pistons in 74.5mm, ported head, 1.2/1.4mm head gasket. Fuel pressure, EMU, Wideband sensor. My questions are:

Must be the TD04L rotaded? Because the output for the pressured air will show to the block. And what is with the actuator? How it must be fixed?

Which injectors must i take? Standard/330/360 or higher?

I hope my english is not to bad to understand :/

Pictures are welcome :D

Greets Alex from germany :)
 
Z

zero_2k3

Member +
Thanks for the video ;)

Today i've dissambled the turbo. Click me hard! I've damaged the intake side... were the red circle on the picture...

I have also the pin removed for rotate. How is the name of this part? The middle! Where the bearings are, the water in and outlet, oil...etc.

This thing must be replaced.

Which Injectors are fit from toyota? The impendance from the stock injectors are 14.8 ohm, right? maybe 7mge?

Greets Alex
 
You must log in or register to reply here.
Top