urgent help required, emanage ultimate

S

Sparky

Member +
Hey guys I need some help asap, car is going for mapping in the morning (nice 3 and half hour drive).

Basically I have wired in the Emanage ultimate (brand new out of the packet) there is power going to the unit and the interaction light is on but there is no spark or fuel.

I have wired it up as per the wiring diagram I got off a member on here.

What could possibly be the problem(s)?

I want to get it up and running ideally before leaving in the morning.

If someone could check their wiring for me just in case that is the issue then I would more than appreciate it! Its for a EP82 m/t by the way.
 
S

Sparky

Member +
Texx said:
Have you configured all of the jumpers on the circuit board?
Click to expand...

I was told to leave them as they came mate

kieran.s gt said:
did you plug into it and set the engine code in parameters settings on the emanage software
Click to expand...

No I dont have the usb cable, I thought you didnt need to do that as its just a piggy back and they come from the factory set to 0 so it will just run off the stock ECU?
 
kieran.s gt

kieran.s gt

Member +
Sparky said:
I was told to leave them as they came mate



No I dont have the usb cable, I thought you didnt need to do that as its just a piggy back and they come from the factory set to 0 so it will just run off the stock ECU?
Click to expand...

no you'll have to set the engine code before it will start.
 
Rory

Rory

Lifer
The parameters need set in the software before it will fire.
It needs to know what car its trying to run.
 
HYBRID

HYBRID

Super Moderator <a href="http://www.toyotagtturbo.
Rory said:
The parameters need set in the software before it will fire.
It needs to know what car its trying to run.
Click to expand...

exactly... otherwise it doesnt know which igniton module or injector drivers to run... also the jumpers need to be adjusted as well.. if u need any help there is a thread with everything about the emu in it, if u still need help drop me a msg and ill do my best to help u out buddy.

kon
 
S

Sparky

Member +
Right I understand now I will see what I can do, is it just the Vehicle Parameter settings I need to put in or do I need to play around with any of the other tabs?

As for the jumper settings I will have a look in that other thread but IIRC it was a nightmare syphing through all the chit chat.

Plus I dont have the USB cable to upload the settings
 
HYBRID

HYBRID

Super Moderator <a href="http://www.toyotagtturbo.
erm its a very simple printer usb cable man.. if u have a usb printer in the house borrow the wire lol..

and yes you have to adjust a few settings in the parameters after you set it to 4efte

kon
 
S

Sparky

Member +
There is a brand new printer in the box somewhere I'll have to dig it out lol

Well I was in the middle of doing the parameter settings the other day, then got confused with all the other tabs so decided to leave it lol
 
S

Sparky

Member +
Thanks for the help guys, just hoping the wiring is right so we dont have to mess about too much tomorrow :)
 
You must log in or register to reply here.
Top