WEPR ct9 manifold (mildsteel) part 3! (starting 28-10-09)

Status
Not open for further replies.

TurboDave

Member +
I fitted mine yesterday, good quality manifold well happy with it.

Only problem was between the flange and runner 2 there isnt enough space to fit a standard nut, even by putting the manifold onto the stud and then doing that one first and bit by bit it physically wouldnt fit so I dremeled the top 1mm or so off the top of the nut.
 

Quick Nick

Member +
I fitted mine yesterday, good quality manifold well happy with it.

Only problem was between the flange and runner 2 there isnt enough space to fit a standard nut, even by putting the manifold onto the stud and then doing that one first and bit by bit it physically wouldnt fit so I dremeled the top 1mm or so off the top of the nut.

Confident in it being completely airtight and not at risk of blowing in time?
 

wickedep

Trader
1: Johnny_B -- shipped
2: starletjosh -- shipped
3: turboloon -- shipped
4: stew --dropped out
5: toyotagt-- shipped
6: TurboDave -- shipped
7: Lairy nick -- shipped
8: Arnold -- shipped
9: Quick Nick -- shipped
10: naevy -- shipped
11: Misterdan88 -- shipped
12. ryan davis -- shipped

finally we are done :beer:

sacha
wickedEP Racing
 

naevy

Fresh Recruit
:rockon:

avatar-1.jpg
 

Misterdan88

Member +
I fitted mine yesterday, good quality manifold well happy with it.

Only problem was between the flange and runner 2 there isnt enough space to fit a standard nut, even by putting the manifold onto the stud and then doing that one first and bit by bit it physically wouldnt fit so I dremeled the top 1mm or so off the top of the nut.

Has every1 done the same thing about the smaller nut? Or just found a smaller nut some where?
 
Status
Not open for further replies.
Top