Wiring in my ultimate fuell cut question

[sammy]

Hey I am wiring in my emanage ultimate at the min and I want to know if I connect analoge input with my map sensor input and analoge out put with my map sensor output to remove the fuel cut? Please only answer if you have experiance or know for certain I dont want to be miss informed.

 

[jarbo]

hoodey, hardcoreep91 and the likes ... jump in anytime.

 

[ragz]

am sure your ment to put in a voltage figure that u want the ecu to clamp so it doesnt fuel cut

 

[sammy]

I thought I had to wire in the analog input and output

 

[Damage]

there is a quicker way to remove fuel cut... there is a map were you give in the voltages at certain rpm to remove the fuel cut. You dont need to program anything. Just have a good look at the program mate.

 

[sammy]

Ya I read about that in the software book but When goin through the install manual I saw the analog wires being used for fuel cut so I dont need to connect them?