would this be ok ?

[cole]

would these wheels be ok for a glanza

4x100 & 4x114.3

15x6.5in

+45 offset

 

[59bhp]

yeah they will be fine as the starlet pcd is 4 x 100

you will just have to make sure the centre bore is correct, do a search to double check but i think its 52mm

 

[Idrees]

+45 offset? Hmm they're going to stick in the arches quite abit, they'll be fine with spacers though I guess.

 

[cole]

what size fit in the arches ok ?
and how much are spacers

 

[cole]

and what size spacers would i need ?

 

[Harvey]

I can never reember which was roubnd it is. Is it deffo be in the arches idrees? Or stick out...

Eitherway its not far off what you need, most run about ET40, so it shouldnt casue much problems.


As for the centre bore, its not 52, its 54mm, you will need to get spigot rings to fit this, unless you are lucky and they were previously fitted to a toyota or mazda and have the spigot rings with them. (unless thet are new of course)

 

[MikeN]

I can never reember which was roubnd it is. Is it deffo be in the arches idrees? Or stick out...

They fall further in the arches. The higher the offset the more they fall inside the arches. A wheel with offset +5 sticks 4 cm more out then the same wheel with +45 (when they have the same width that is) .