dac69er
Super Moderator
After about 15 years, I am finally getting round to fitting the trd arb I bought!
As I have a mk1, it has the oldskool droplinks and the trd arb uses the newer balljoint type.
Looking at the length of the originals compared to the ones IDworkz sell, the IDworkz ones seem alot shorter.
Has anyone purchased any of the of the IDworkz droplinks to confirm they fit ok?
I have had a guestimation measure up and I think they should be fine, but would like confirmation.
I have found some mk3 mr2 droplinks which I think should do the job fine, but they look a little too long if anything, but it is very hard to tell.
Any guidance would be appreciated. Thanks
As I have a mk1, it has the oldskool droplinks and the trd arb uses the newer balljoint type.
Looking at the length of the originals compared to the ones IDworkz sell, the IDworkz ones seem alot shorter.
Has anyone purchased any of the of the IDworkz droplinks to confirm they fit ok?
I have had a guestimation measure up and I think they should be fine, but would like confirmation.
I have found some mk3 mr2 droplinks which I think should do the job fine, but they look a little too long if anything, but it is very hard to tell.
Any guidance would be appreciated. Thanks