GTnomez
Member +
Rights guys
I installed my turbo (td04) yesterday whit a screamer pipe (internal). I cranked it yesterday and started 1st time but i didnt drive it. Drove it today and i couldnt get past 0psi! it goes from minus (-) 8 or whatever but the needle and reading dont get past 0
i checked the vacuum pipes in the inlet and the dumpvalve. there were fine and connected. No high idle from a vacuum leak.
I took the mesh off the turbo.
i checked the boost pipes on the actuator and turbo, i disconnect my boost solenoid and ran it direct from the actuator and turbo.
i wound the actuator all the way in so there was tension on the wastegate arm
the intercooler pipes were all tight, no whistle or total loss of power.
there is no smoke at all and i can spin the turbine easily.
i did all of this and no difference at all!!!!!!!! i think it can either be the turbo or the actuator!
help!
thanks
I installed my turbo (td04) yesterday whit a screamer pipe (internal). I cranked it yesterday and started 1st time but i didnt drive it. Drove it today and i couldnt get past 0psi! it goes from minus (-) 8 or whatever but the needle and reading dont get past 0
i checked the vacuum pipes in the inlet and the dumpvalve. there were fine and connected. No high idle from a vacuum leak.
I took the mesh off the turbo.
i checked the boost pipes on the actuator and turbo, i disconnect my boost solenoid and ran it direct from the actuator and turbo.
i wound the actuator all the way in so there was tension on the wastegate arm
the intercooler pipes were all tight, no whistle or total loss of power.
there is no smoke at all and i can spin the turbine easily.
i did all of this and no difference at all!!!!!!!! i think it can either be the turbo or the actuator!
help!
thanks