hi ive tried searching the forums about this specific electrical part of our 4efte but i cant seem to find the right thread.. anyways i have a problem with this parts.. my car was converted to left hand drive and now i think the electrician failed to reinstall the ELS (the part that makes the...
ive got a problem with the engine. when in idle everything is ok but when i rev the engine dies then i start again and the same thing happens or sometimes it takes timeto start.. what could be wrong?
any help will be apprieciated..
cheers
hello sir,
i heard good things things from friends about your business here and that you can source out hard to find parts and i was wondering if your able to source out a few things for me. i know you have a thread there but im not sure if its alrght to post what im looking for there..
1...
if anyone have the following things that im willing to buy pls send me a pm
1. emanage blue ignition harness
2. emanage blue injector harness
3. Gifftech usb to usb cable or other brands that are about the same for the emanage blue ( i cant seem to find a laptop with a serial port...
yup that helps a lot mate thanks.. and one last question the line from the turbo itself where should that be tapped? im doing this on my own so any bit of help will caount
thanks and cheers
im restoring a4efte to its factory specs. i was wondering if anyone has got a diagram or a picture of where the vacuum lines should go? any help would be appreciated.
cheers
thanks for the answers.. ok so the glanza V works.. no need to change the wiring loom i guess right? if anyone has the part number of that ecu that would be appriciated
thanks again and cheers
as the title says.. i have a matic ecu becausethe ep82 i have has been convertedto manual. the question is if i want to change the ecu into a manual ecu what are the things do i have to change?
do i need to change the wiring loom or is it just plug and play?
cheers :)