Search results

Is the engine standard mate? Sorry if I missed the spec of it Ellz

will you post the seats? Ellz

Cool, cheers all, still waiting for the actuator to come, so wont be fitted and dynod again till after my holiday, Ellz

Nope not forged dude. Just waiting for a forged engine to come up. Will let you no the outcome with the new actuator and a tweak with the fuel presure Ellz

Sweet, hope it hurrys up! i go on holiday in a week so looks like itll be after that Ellz

heres the graph.. at 5500 revs it starts to loose boost. Ellz

Cool. I'll upload my graph in a min and you'll see were it starts to drop off boost. Ellz

Hey all. Recantly picked up a glanza v. Few Mods inc a td04 I got told it was at 1 bar, Went to adtom automotive in birchhanger Essex and made 189.9 bhp at .9 bar boost. Also have a weak actuator as drops off boost at 6500 revs. Orderd a forge actuator and will be going...

yeh i have seen a few on here with them lights, isit a sttight swap or is wire cutting involved? needs new headlights as it did have eyebrows n but were they been taken of has ruined the hedlamps, Ellz

Cheers, should look much nicer after a good compound and polish to bring the paintwork back up to scratch. think ill remove the rear tints to, abit to dark for my liking Ellz

No need to apologise mate.

Yep couldn't do a stright swap with yours. Least with this I got what I needed. And it was what I'm looking for Ellz

Hi Again.. picked up the glanza on thursday, had it rolling roaded on sunday, its at 189.9 bhp at .9 bar boost, it has a weak actuator atm so drops of boost at 6500 revs, so a forge one has been ordered and will be set up at 1 bar boost so should see over 200 bhp, Heres a few quick pics.. Ellz

cheers, i have solder ect and wire clamp. i am a tech for renault but as i have only just got this car and no nothing about the glanza i thought i would ask the exsperts, Cheers all Ellz

SORTED. Just want to say a big thanks guys, once i new were to start map sensor, i used a test light and i wasnt getting any live feed to it or my fcd.. so i followed the wire around the car and it dives inside the car. preivouse owner had decided to attach it to the radio live... and...

thanks for the help so far guys, the fault code is 31... so MAP when fitted- Open circuit in map or short circuit VC Any ideas? i must have disturbed a wire for it under the drivers foot well? Ellz

Hi, cheers for the link will do that asap and report back, it is a hks turbo timer, on the back of it it has 2 wires with multi plugs on then a black hollow pipe, which i thought a vacume pipe would go on so it can measure boost aswell? if not then im unsure where this vacume pipe goes...

i ment i have put the pipe into the back of the hks turbo timer, didnt really make any differance, to do a diag test i would need a reader? or is their another way? were is the plug to put the reader in? Ellz

Will get pics uploaded later when i finish work, i have blocked the pipe off and plugged it into the turbo timer, still wont boost properly, also the eml light is on, i will check the the map sensor now, i have vacumed the actuator but when i pump it, it just lose's pressure, dosnt hold...

the car wont boost over .5bar then when it comes to .5 bar it coughs and splutters and the needle of boost gauge just goes up and down up and down, i have a new actuator on the way for it and new ht leads, i do have a turbo timer but this reeds the boost to, is their ment to be a vacum...