Search results

  1. O

    Engine tight in one place when turning over by hand

    As above, was fine off the car, timing all checked.starter motor removes and in neutraland still wont turn. Defo turned over before gearbox clutch flywheel etc were fitted. Cant remember if i turned it over after fitting. Update took the plug out and dropped some oil down the bores. Turns...
  2. O

    Clutch for 1bar td04 and 4efte Crank Pulley

    As above
  3. O

    11.5AFR on idle and cruise

    Fitted a walboro fuel pump and still on the standard FPR.It seems since fitting the pump, On idle the car runs rich(11.5-12), however when i give some throttle it leans out to 15. On boost it drops back down again. But crusing at 11.6. What could cause this? Possible the standard fpr cant...
  4. O

    Electronic Boost controller not increasing boost

    Fitted my greddy profec spec 2 today and nothing i change seems to boost above spring pressure. Running a tial ext gate. Currently have vac line from turbo nipple to bottom port on wastegate teed off to NC on the solenoid. Then have comp going from the solenoid to top port of wastegate.this correct?
  5. O

    Glanza field Harness

    For an emanage blue so i dont have to hack into the main loom
  6. O

    Passengers side or both side non lsd driveshafts

    as above
  7. O

    Front Coilovers

    Glanza Coilovers Whole set..budget £350
  8. O

    Ideas??!!! very worrying knocking noise

    Sounds like its coming from the driveshafts, only does it occasionally above 2,000rpm and when turning the wheel slightly. Sort of come from nowhere yesterday. Im leaning towards cv joint? Noise disappeared for a day and now has got worse. Seems about 2,000rpm the knock,knock,knock starts...
  9. O

    After-market ct9 manifold

    As above, no cheap ebay ones please. Unless have been properly welded and strengthened!
  10. O

    Revs drop to 0, check engine light, doesn't stall

    Started on the way home a slight judder/misfire around 2krpm.just went out again and was worse. Revs even dropped to zero then went back up again this time. Happened a few times and conked out once and wouldn't restart for a while.any ideas what this could be
  11. O

    CT9 Front Mount Intercooler

    as above
  12. O

    Glanza Key Fob Programming

    Just brought a key fob direct from Japan, genuine toyota that i was told works with a Glanza. I've followed every guide on the internet i can find and can't programme the key. Has anyone else got a two button remote and have it programmed? Or do i just accept its not gonna work with a glanza?
  13. O

    Wanted

    Wanted-Adjustable Panhard Adjustable Panhard rod needed
Top