Search results

hello, how to fit oversized valves on a 4e? seats need to be replaced or i just make them bigger for the oversized valves? can the seat be changed on a 4e? thank you

hi hybrid, it seems you know a lot about greddy ultimate. i ve a few questions, may be you could help me ive upgraded greddy blue to an ultimate one, using the harness for the blue. when the ultimate is plugged on, the unit stays on after removing the key. when putting back the blue, its ok...

hi dan, do you have quaife lsd for glanza? how much please? shipping: France postcode: 94600 thanks

re Ok, I live in an island, sea level and min température is about 20 deg C. Its summer at the moment so I Will try it and if it ' gets hard to start up the car I ll put it back, cheers

So if I dont want this problem to happen, I get a vacuum to it? Am I right?

re Thanks for your reply mate. Today I managed to fit the intake mani. I blocked all the nipples and see how it goes. I ll tell you how it run.

Hi everybody, I m fitting a zisco intake mani With stock throttle body. I need more clearance anyway is it ok if I block all the pipes of the throttle body, the 2 water hoses and the others for air. I have no air con, no power steering, and now With the New mani no idle valve. Thanks

[ I think it the speed limit dedefencer as your have a blitz ecu

Thanks mate

Re For exemple if the car is dropped 5mm do i need make holes 5mm up to fit rarb brackets so the bar is not tensioned

Hi i have a rear antiroll bar fitted on my ep81 châssis. So the shocks are for the na. now if i fit coilovers will i need to re drill holes for the brackets ? Hope your understand what i mean ;) thanks Also the ajustable Panhard rod should ne installed before the rarb?

hi Is the kit still for sale wastegate included

total to france please, postcode 94600

pmd.

94600

hi, are the front shocks still for sale? shipping France. thank you

hi mate, yes please update the thread. what is the total for the whole lot delivered to France; thanks

Fse is the kit. "walbro" is stamped on the pump itself if it is one. i bought the same box and it was written walbro

re hi, i ve been driving the car for a week now. the flange is still ok. i will put a pic later. And no the mani not ported, its a zisco one (thats why i didnot want to get rid of it). The afr' s are correct. My first dyno the car pulled out 168.9hp with ct9. I m verry happy with this new...

re thanks, what i did today is weld the tringular flange to the ct9 mani but the td04 downpipe is not aligned with the exhaust. So we cut the down pipe in two bits so we can rotate it to fit. i need to re weld the downpipe now... i hope it will work. http://hpics.li/40a8f10