Vincent-ep91
Member +
Hi lads,
my avcr is set to 1 kg/cm^2 in the Boost/Duty setting.
The Wastegate is equipped with a .4Bar spring .
The problem i have is that the Solenoid duty has to be almost maxed out just to get to 1 Kg/cm^2. Why would this be the case.
I have gotten rid of the HKS blow off valve and blanked it off incase a boost leak was caused by a faulty B.O.V.
Madman installed his solenoid to check if mine was at fault but it gave the same readings.
Would i be correct in saying solenoid duty should be at around 40% and not around the 80% region to achieve 1 Kg/cm^2 ? What could be at fault?
my avcr is set to 1 kg/cm^2 in the Boost/Duty setting.
The Wastegate is equipped with a .4Bar spring .
The problem i have is that the Solenoid duty has to be almost maxed out just to get to 1 Kg/cm^2. Why would this be the case.
I have gotten rid of the HKS blow off valve and blanked it off incase a boost leak was caused by a faulty B.O.V.
Madman installed his solenoid to check if mine was at fault but it gave the same readings.
Would i be correct in saying solenoid duty should be at around 40% and not around the 80% region to achieve 1 Kg/cm^2 ? What could be at fault?