Brendanlez
Member +
Can anyone help with the AVCR wiring into the ecu cheers, diagram would also be helpful
Rep waiting
Rep waiting
AVCR Wiring Diagram
- Thread starter Brendanlez
- Start date
Brendanlez
Member +
cheers lad but how do i tell which is which coming from the ecu?
kieran.s gt
Member +
use the ep91 ecu diagram http://www.toyotagtturbo.com/forums/showthread.php?20491-EP82-EP91-ECU-Pinout-Diagram
Brendanlez
Member +
Your a legend lad
Brendanlez
Member +
Should I put the throttle wire (Grey) to
10 on 16 pin plug - Throttle position sensor
11 on 16 pin plug - Throttle position sensor (pin 1)
12 on 16 pin plug - Throttle position sensor (Signals ECU Throttle position is at idle)
Please help
10 on 16 pin plug - Throttle position sensor
11 on 16 pin plug - Throttle position sensor (pin 1)
12 on 16 pin plug - Throttle position sensor (Signals ECU Throttle position is at idle)
Please help
kieran.s gt
Member +
the throttle wire isnt used in these cars just leave that wire disconnected
Brendanlez
Member +
It wont turn on at all for me, I have it wired according to the pin outs etc
Edit: Got it sorted, the connectors I used bares the wires but the connector for the ignition signal squeezed the wiring covering not slicing it
Thanks for all the help
Edit: Got it sorted, the connectors I used bares the wires but the connector for the ignition signal squeezed the wiring covering not slicing it
Thanks for all the help
Last edited:
glanzadude
Lifer
Now that is handy as I am thinking of geting one, thanks lads
Brendanlez
Member +
i can take a pic of it if you want ill post up l8r exactly wer everythin is wired toto
starletgtturbo1
Member +
bump this up, cant get the thing too work
Rory
Lifer
Did you test it before fitting? Aye shoving the positive and negative on a battery?
Wha did you use to wire it in?
Wha did you use to wire it in?
weeJohn
Lifer
Throw them in the bin, they are shite.
Strip a piece of insulation off (about 1cm) the wire you want to connect to with a knife, wrap the stripped end of the cable you want to connect around it and then solder it up and tape it up well.
The screen should light up as soon as the power is on, is it?
starletgtturbo1
Member +
yeah it was swapped from one starlet to mine, ive got it working on my mates car right now.ive got a new ecu comming this week, so il wait till it comes then try again, then il have to figure out how to wiring the ecu to haha