BackBox Bushes?

[biscuit]

Mine is buggered, perished as you like, so the exhaust is hanging a bit low on the rear. Got some polyflex ones from TM Dev's, but I can't figure out how the hell you are meant to fit them to make them sit as high as OEM.

Anyone?

 

[Zen]

Mine is buggered, perished as you like, so the exhaust is hanging a bit low on the rear. Got some polyflex ones from TM Dev's, but I can't figure out how the hell you are meant to fit them to make them sit as high as OEM.

Anyone?

you where off getting biggers ones if they are tight there will be no flexability mate

 

[biscuit]

same as this - what way to i do them?

 

[Gryzor]

a bit of washing up liquid for lub and you should see them on easy enough

 

[biscuit]

I can get them on, but it's how I hang them to get the exhaust to sit higher.

With them through the further holes it sits lower than OEM

 

[durmz]

I can get them on, but it's how I hang them to get the exhaust to sit higher.

With them through the further holes it sits lower than OEM

u sure uve got the right ones then? because they should be same length as oe, mine are

 

[jjayokocha]

fitted my mates jperformance system on sat and it hangs a bit low aswell. He was thinking of cutting about 1inch from the hangers on the backbox to raise it up a bit,

 

[biscuit]

Well I've fitted them using the closer holes, but still a gap like there was before

I've cleaned up and fixed the OEM one, so once that's all hardened up I might re-fit that and see if it works.