Boost creep, but no FC. Any help?

[tjwilson-glanza V]

Hey guys, i'm running standard ct9, HKS Actuator, with zisco manifold and downpipe, with relocated air filter and ported wastegate and few other bits not really worth mentioning as i don't think it will affect this...

I've set the Actuator to 0.8bar, as i didn't want to go above as i 'knew' i'd hit fuel cut as this happens at 0.82 or soo...? When i hold high revs i get boost creep bringing the boost to around 0.9-0.95, yet i don't hit fuel cut. I've checked the ECU and its the standard 4efte ECU, checked around for FCD and can't find anything, yet i don't hit fuel cut??

The only thing i can think of is my boost gauge being wrong, is this likely? If not is there anything anyone else suggests whats up? I'm happy it doesn't hit FC, however don't really want to be going over 0.8..

Thanks alot, Tobie

 

[jason_sureshot]

If the boost gauge shows a steady increase, and it is firm and not flickering, i dont see it to be the boost gauge.

 

[markostarletturbo]

Have you checked your ecu ? previous owner might have fitted aftermarket ecu? or like you say may be there's a fcd some where on the car? make sure your actuator is adjusted correctly use this mate

www.tercelreference.com/articles/hks_actuator_installation/hks_actuator_installation.html


Sorry my bad just read you checked ecu

 

[tjwilson-glanza V]

Yeahh i've checked all those things, no worries . Thanks for the link i'll measure mine tomorrow evening to suit 0.8 and see if mine is anywhere near that. Thanks alot.