boost hesitation

D

dave-izzle

Member +
when i'm driving, using boost up 0.6 bar, everything's fine and the car is really nippy, but when i boost over 0.6 all the way to 1.1 i.e full throttle, you can feel the boost hesitation and the car holding back.

These are my relevant engine specs:

Apexi AVC-R electronic boost controller
Mines ECU
FSE fuel pump
JR breather filter
HKS mushroom filter
HKS adjustable actuator
Blitz Nür Spec R Exhaust system
Japspeed De-cat pipe
Blitz super sound dump valve

any ideas people?
 
A

Adam_Glanza

Member +
your turbo is probably out of its efficiency zone and just basically heating up the air, turn it down to maybe .9 bar and see if tis any better
 
Craig

Craig

Lifer
A FMIC or thicker TMIC should help. Would be advised to run uprated IC on that much boost mate.
 
D

dave-izzle

Member +
FMic was definatly next on the list, but since my got keyed, i will be spending the cash on repair bills and perhaps exterior sensors for my alarm.
 
You must log in or register to reply here.
Top