Brake conversion!

[zetecmad]

was thinkin about doing this as i seen one or two for sale, is it much work to change my rear drums to callipers?? i know i need the new axle etc but how hard to fit?? and would i have any problems with brake setup then?

 

[Derek]

Get a glanza v rear axle and bolt it on, i thought would all it would be. and a bit of brake fettling.

 

[Rob H]

you dont need the full axel you can unbolt the axel ends and swap them over but its not much harder to change the hole lot but you will also need the hand brake cables too and I think the balance bar that the 2 cables go onto at the front is a bit different too but some one should be able to sell you the hole job lot anyway