Tim@TBDevelopments
Lifer
this has been a busy week, managed to get a start on thomas's 3sge to 3sgte engine conversion.
While john took the na engine out i was busy building up the 3sgte to replace it. The engine going in has had a total rebuild from top to bottom, but retained most of the standard parts like rods, crank etc. just had a set of uprated bearings, ARP head studs and CP forged pistons to give some margin against the dreaded ringland failure. All genuine new gaskets, pumps etc as standard
While john took the na engine out i was busy building up the 3sgte to replace it. The engine going in has had a total rebuild from top to bottom, but retained most of the standard parts like rods, crank etc. just had a set of uprated bearings, ARP head studs and CP forged pistons to give some margin against the dreaded ringland failure. All genuine new gaskets, pumps etc as standard