down pipe to exhaust gasket? where from

[karls_car]

been lookin on net for the three hole exhaust gasket that goes from down pipe to rest of exhuast system, but can only seem to find ones with two holes?
done a search on here, and on ebay


where should i be looking for one?

cheers karl

 

[GTnomez]

i dont think that there is actually one, i never had one

all i had to do was make sure the inner ring was in the decat to seal it and the use of past aswell and its fine

 

[madman]

i dont think their is one either but am open to correction.. but if i was you i would use exhaust sealent about 5quid in your local motor factors

 

[dac69er]

there should be a compression ring type gasket. fits in the groove in the cat, and in some decats. if the faces are clean then you shouldnt need any paste

 

[ChrisGT]

The Autobahn de-cats come with a gasket, which I'm using at the mo and its holding strong! You can see it here: http://www.siliconhose.com.hk/ebay/Z87b.JPG

Its one of those cheapy made gaskets, but I didn't have anything else to use and so far its not blowing! So all good!

EDIT:

You need something like this, http://cgi.ebay.co.uk/3-exhaust-gas...14&_trkparms=72:1683|66:2|65:12|39:1|240:1318, but 2.5".

Ask this seller maybe: http://cgi.ebay.co.uk/Massey-Fergus...14&_trkparms=72:1683|66:2|65:12|39:1|240:1318

 

[Suspected_Psycho]

AAHAHAHAH I want rep for this one ppl!! - I couldnt find one for a long long while.. but Eventually I did.. The company is owned by fensport and the link is..

http://www.blitz-uk.co.uk/Product-14.aspx

I have: 45019 Exhaust gasket for MT3230, 60mm diameter, 3 bolt fixing 11mm x 80mm pcd and it fits a little oversize, but perfect sealing capacity!!

Least now it dosent smell of fumes in the car

ps. The compressed ring is pants, try doing that up and getting it perfect, dosnt actually work if theres no grove!

 

[dantheman]

karl small detail you forgot to mention to these chaps is its a WEPR DOWNPIPE AND WEPR flange.. so the pitch between the holes is different to normal..

i used a blitz gasket like above and enlongated the holes and it sealed fine.