ECC Nissan GTR Consult III

[John@ECC]

Hi guys we have just purchased a Consult III which is the same machine as Nissan have for their whole range of cars, this is essential when working at the new R35 GTR's for setting the clutch touch points after a rebuild or at each service, tyre pressure warning lights, engine management lights etc. We have even got an oscilloscope with it.

We will be considerable cheaper than Nissan for any of the above so give us a shout if you know anybody looking something done.

 

[Rob H]

we have one of these at work very good bit of kit too but I much prefer the volvo V cads to use ya just plug it in and it basically does it all for ya not like the nissan/renault one. I think they should put renault badges on the skyline for the laugh as they own nissan anyway!!

 

[turboloon]

can you use this consult on pulsar gtir's...?