emanage ultimate

[starlet666]

ok so i got one and wired it in.... i had everything but spark....... dunno why i know for a fact i had everything correct... can anyone say what i could have done wrong??????? cause i know i had the right wire intercepted but it just wouldnt make a spark at the coil......

 

[azerty]

have you entered 4efte profil in software and uploaded to EMU?
if yes, well then it comes from your wiring...

 

[HYBRID]

i hope u chose the diagram for "distributor ignition" ... its just 1 channel

 

[starlet666]

i know i had the right wire though......... it was yellow from memory... i will double check it but im certain that was the one....... dunno just really wierd that fuel would control....but the spark wont...... and im not goin 2 leave it as a fuel computer not for the money i have spent on it

 

[HYBRID]

lol.. look at the bright side, till i got some wireing sorted my emu was just a very expensive fcd lol :homer:

now its another story....

so the ignition table is as follows : u should have 2 wires connected to the harness:

on the stock ecu side (t) the colour to cut & connect is Blue/White (L/W for emu users)
on the sensor side the colour to cut & connect is Blue/Black (L/B for emu users)

check ur wireing man, it doesnt sound right from what uv said..

kon

 

[starlet666]

will double check mate but im certain i followed the pin layout perfectly........but will get back 2 ya