Engine swap, help identifying few loose ends please

td04 project:)

td04 project:)

Member +
I removed the engine somewhat months ago and fired a new one in at the weekend but im left with a few pipes, sensors etc that im not sure about if anyone has any help it would be greatly appreciated :)

1) Firstly this is on the front of the block and i cant see anything that plugs into it, What is it and does it need to be connected?

20130407_140840_zpsfe9a0871.jpg


2) The two blue prongs? Dont have a clue what they are? they are just under dizzy.

20130407_141142_zps998f22c9.jpg


3) The grey triangular electrical connector? what is it and does it need to be connected?

20130407_140907_zpsa9fdb8d2.jpg


4) Not sure what this is but it has two vaccum hoses connected to it and one isnt connected to anything!

20130407_141016_zpsf6ef46d3.jpg


5) The two red and black prongs, what are these? Im guessing they are some sort of vacuum?

20130407_141510_zpsb9866f97.jpg



Any help would be great im trying to get it running for next weekend so just want to clear these up asap :D

Allan
 
5e colin

5e colin

Member +
nr1 is oil pressure sensor the connector is attached to the loom that goes to ur thermo housing

nr2 ???? blank it

nr 3 is a sensor that either goos to ecu or gauge yes need connecting

nr4 looks like airco shite u can blank it if u want

nr5 goes to tb

and deffo re set ur timing coz its way off see dizzy pic
 
5e colin

5e colin

Member +
yes ur ignition timing is way off ( NOT ENGINE TIMING ) it shud be 10 degrees and i can see its way off
 
td04 project:)

td04 project:)

Member +
no mate its always been a glanza but this is the third engine ive had in it, the last setup i had was a td04 with no water lines thats why im not to sure about them.
 
You must log in or register to reply here.
Top