neilelliot_1
Member +
where do i find these? cheers!
to check error codes? dont go to any garage!
do it yourself.
http://toyotagtturbo.com/forums/showthread.php?t=290
if its a glanza you will find the diagnostic port on the bulkhead near the ignator.
cheers mate might save me a few pound in the futher!! would u need to buy a diagnostic tool??
lol very sorry if im a bit slow mate but where do u attach the other side of the wires??
you have 2 points int the diag port.. one is te1 and the other is e1. so one end of the wire goes into the te1 point and the other end in e1. you go into the car.. switch the ignition on and read the flashes then then number of flashes youl get match the error code as per that link i gave you
no ull need a bit of wire stripped at both sides to push in to the diognostic ports