fan running constantley ep80

[gtpower]

Hi all having a bit of a dilemma ive after doing a full 4efe conversion into my ep80
the car used to be a 2e-e 12v ive after fitting a complete engine bay wiring loom complete with dash loom all from a soleil starlet so looms are all complete no chopped or butchered wiring

the fan runs as soon as I switch on ignition ive done the usual new rad fan switch fitted a air-con pressure switch relay tried bridging the air con pressure switch plug as a few have said to do and still runs

only way it stops is if I remove the fan relay or a 20amp fuse located in engine bay fuse box 2nd from bottom

im at a loss ive tried relay for fan/ 2 other rad fan switches these are the white ones located in thermostat housing I even tried a glanza one the green one with the little tabs filled down so plug would fit and still runs am I missing something

to ad there's a long white connector that Is located behind the glove box when I fitted the loom this had no where to plug into the blue and white plugs did everything else works correctly

sorry for long post but its doing my nut in

 

[turbominicooper]

if ac is removed bridge pins.

check thermostat... if its stuck open fan will constantly spin.

check wires to thermo housing, a corroded cable on the thermo will cause it to spin constantly.

check fan relay and replace if necessary.

 

[gtpower]

if ac is removed bridge pins.

check thermostat... if its stuck open fan will constantly spin.

check wires to thermo housing, a corroded cable on the thermo will cause it to spin constantly.

check fan relay and replace if necessary.

my car never came with ac the loom has this feature ie all the connections for an ac setup my car never did
im going to check thermostat as I changed thermostat housing to suit connections my loom has (green) plug 2 wires and a single grey push on connector
i'll have to open the loom up and check wiring
ive tried 3 or 4 fan relays from other cars and still once connected fans turns on