FCD wiring!!

[ep82lunacy]

I wired my FCD last Thursday.. After a bit of confusion with the diagram I started wiring and all went well...Maybe I am going mad or something but I just feel as if I wired it the wrong way around or something.. If I did wire it wrong would the car still start because its running perfectly as far as I can see

 

[Derek]

If its running perfect you obviously wired it up right.

 

[williamocarroll1982]

Red goes to Ignition live
Black goes to Ground

Cut the PIM Volt wire (wire from map sensor to ecu) and connect the yellow and white wires with the yellow wire connect to the ecu side and white wire connected to the loom side

If the car is running fine and you can boost beyond 0.82 bar then its working

 

[ep82lunacy]

Well even though I used the diagram I managed to mix up the wiring.. If anyone could tell me what colour the positive/live wireis on the ecu I will know where I messed up.. Cheers..Reps waiting

 

[zetecmad]

Well even though I used the diagram I managed to mix up the wiring.. If anyone could tell me what colour the positive/live wireis on the ecu I will know where I messed up.. Cheers..Reps waiting

positive wire as far as i can remember is a brown and grey?
i checked wiring diagram for ep82 think u went wrong on the earth heres diagram i changed

 

[ep82lunacy]

According to my calculations the positive wire is green and yellow?? Can someone confirm this before I burn the car

 

[ep82lunacy]

All sorted made an amateur mistake!!!!

 

[zetecmad]

what was it in the end?