Final fitted my front mount

[Sticks]

So here it is

Cheers
Mark

 

[Starlet_Sam]

You've been very brave with the cutting of the bumper, do something with it so it looks like it was made that way and it'll be cool.

 

[HutchGlanzaV]

Agree with Sam, the bumper looks a bit hacked but like the front mount, I know its there to serve a purpose but I reckon front mounts look the tits!

 

[Starlet_Sam]

It's just the sides where you can tell it's been cut. The rest looks good.

 

[Sticks]

What do you recon i should put there?

 

[dantheman]

think you should have just cut out the bit where the plate usually sits and left it at that.

 

[Sticks]

think you should have just cut out the bit where the plate usually sits and left it at that.

I thought that but then i thought i will not get the full effect of the front mount.

And i quite like it like that. I think the pictures don't do justice really.

 

[dantheman]

dont get me wrong it looks like you done a neat job out cutting it

but to be honest mate i doubt it will be getting any more air as it is now, compared to if it were just the number plate section cut out, because the bumper is pretty vented as standard.

still, you done it now so what can you do , as long as your happy with it dude

 

[Sticks]

I seen a couple on here with just the number plate cut out and it did look good but i cut it before i looked. Thats me for you

I think i will look around before i do anything else again

Cheers Buddy

 

[jamesbaa]

what did you use to cut the bumper?

 

[Sticks]

Angle grinder

 

[jamesbaa]

i bet that was scary!

 

[Sticks]

It was just a small disc one but i thought that would be the easyest way

 

[stuart]

Stick some mesh over the front of it mate!

know its a gt bumper but:

 

[ryan_v]

did u notice any difference in power with afront mount?

 

[Sticks]

Haven't really had a go in it yet as i am still waiting for paint to dry

 

[AntiguaGT]

should have cut it a lil closer to the piping so it would have looked like it came like that..

 

[chinaone]

I think you done a very good job cutting out the bumper. You should just tidy up the bottom coners, than it'll look the tits.

 

[Greg0r]

i think it looks good

have you removed the crash bar aswell?

 

[Sticks]

I did have to remove the crash bar as it would of not fit