fiting cv joints??

TURBO2010

TURBO2010

Member +
hey lads woundering how do u go about changing the cv joints? what tools u would need and any tips would b very helpfull and what type of joints i would need for an ep91?
 
stuarty1

stuarty1

Member +
loosin the theel nuts a bit and then jack up the car take the wheel off and the will be a split pinn use plyers to pull out and the whell hub nut is size 30mm use a beep 30 as a normal size will slipp off once it is off there are 3 bolts just under the disc size 14mm take them out lever it down with a bar or eney thing realy hit the end of the cv joint but put the 30mm nut on a we bit so you dont damage the thread that will pop it out and remove the metal clips over the boot with some snips hold the shaft tight so you dont pull out the drive shaft simply hit the end of the cv joint with a hammer make sure i straite and will pop off and do the procesin reverse to put bck on hope that helps pm if you stuck
 
You must log in or register to reply here.
Top