Hi guys,
Just got a speedvision 1.6mm metal HG, 5-layered steel. Question is, is it necessary to take off the rivets holding the gasket together, fitting them one by one onto the block with a layer of copper spray in between each layer?
Another question would be ; What difference is that 1.6mm one compared to three pieces of 5efe metal headgasket (0.5mm each), and two pieces of trd 0.6mm gaskets being sandwiched together(taking into consideration we're comparing this to a 1.2mm metal HG)?
Just got a speedvision 1.6mm metal HG, 5-layered steel. Question is, is it necessary to take off the rivets holding the gasket together, fitting them one by one onto the block with a layer of copper spray in between each layer?
Another question would be ; What difference is that 1.6mm one compared to three pieces of 5efe metal headgasket (0.5mm each), and two pieces of trd 0.6mm gaskets being sandwiched together(taking into consideration we're comparing this to a 1.2mm metal HG)?