Fitting my front mount.

[simonjp]

i just got my autobahn front mount off dave and i have a go at fitting it.

its all mounted stardet running the pipes and the one that comes from the turbo up and right over the manifold. the sensor poking out the exhaust is in the way.

anyone else had this problem. i will get some pics soon.

also whats the way around it.???

 

[simonjp]

 

[patglanza96speedy]

mate i get mine off dave the end of the week i give it a try an give ya few tips on it mate

 

[stuart]

I didn't have this problem when I fit my autobahn one :s

will have a look see under bonnet in daylight tomorrow and take a pic

 

[simonjp]

i got a decat though. dunno if that makes a difference.

 

[simonjp]

help?

 

[Paddy]

are u sure the pipes are the right way round

 

[Fishy89GT]

its because the bung for the sensor on the decat is in a different posistion to most of the others hence why the piping is hitting it...

 

[Aidan@EP-styling]

its because the bung for the sensor on the decat is in a different posistion to most of the others hence why the piping is hitting it...

^^^ True.

the answer to that would be to play about with the pipes imo.
maybe loosen them off at the bottom and try push them closer together or something

 

[madman]

send it back and get a HDI one!!! :rockon:

if you know any fabricators they could weld an extention into the piping thats what id be doin in your situation...

 

[Sticks]

I have a little room between the sensor and the pipe and i have the cat still in.

 

[Sticks]

Damn, just seen that you said decat. Maybe thats why :homer:

 

[simonjp]

i cut the pipe in half and used a bit of silicone to extend it about an inch then i just about squeezed it in.

works now