Glanza 0-60 mph! What would be the 0-60mph Ct9 Running 1 Bar?
- Thread starter Paul_JJ
- Start date
So it's 6.9 Sec with 1 bar of BOOST?????
210ft/lbs - how much BHP is that - around 200???
HYBRID
Super Moderator <a href="http://www.toyotagtturbo.
well put it this way.. the 0-60 is pretty much speculation .. to really know ud have to try a time attack on a dyno..
as for torque to bhp... i cant really suggest, as you may have a very high bhp car with very little torque (ie focusing mainly on acceleration) or you may end up with a setup of much more torque than bhp (as commonly seen in very rich/retarded situations or on diesels..)
hope that helps
kon
as for torque to bhp... i cant really suggest, as you may have a very high bhp car with very little torque (ie focusing mainly on acceleration) or you may end up with a setup of much more torque than bhp (as commonly seen in very rich/retarded situations or on diesels..)
hope that helps
kon
OK. thank you for that!
THen I need to know if someone who has a Glanza with 1 bar CT9 did a dyno and what was the 0-60 - of course every car would vary depending on the mods, but I want to see the average! -)
Last edited:
finx
Member +
agreed on pub talk comment.
depends on so many variables its very very hard to state exactly what time it would do. driver and conditions all come into play
best acceleration test is at the drag strip however
calculated off the drag time slips (i did over 60 passes last season) and confirmed to within .1sec on gps system of a mates my ep71 with ct9b at 10psi does 0-100km/hr (60mph) in 4.9sec and 0-135 (84mph) in 8.2sec (thats half track down the qauter mile) and for those that are interested or who are at the bar talking smack while on the old wifi connection, full qauter mile ET is @ 13.22sec
depends on so many variables its very very hard to state exactly what time it would do. driver and conditions all come into play
best acceleration test is at the drag strip however
calculated off the drag time slips (i did over 60 passes last season) and confirmed to within .1sec on gps system of a mates my ep71 with ct9b at 10psi does 0-100km/hr (60mph) in 4.9sec and 0-135 (84mph) in 8.2sec (thats half track down the qauter mile) and for those that are interested or who are at the bar talking smack while on the old wifi connection, full qauter mile ET is @ 13.22sec
Stulet-GTT
Member +
Its all willy waving, you have no willy so cant wave...:haha:
I know it's a pub talk - but most of the cars compare by 0-62 mph time! And as a standard STARLET GT 0-62 is 6.9 sec, I had no idea about the Glanza V and in particular an AUTO version!
I have an auto as well, and I'm pretty sure it has 4 gears + the overdrive is 5th! I do 100mph in 5th gear and have 4K RPM, 120mph and 5K RPM.
I've noticed that all the starlets and glanza's have A242E - E means that this is an electronic controlled, but there are different versions of those gearboxes depending on the year! By the way the Gearbox was specifically designed for our cars and Toyota didn't use it on other cars!
Rev what Year is your car???
I have an auto as well, and I'm pretty sure it has 4 gears + the overdrive is 5th! I do 100mph in 5th gear and have 4K RPM, 120mph and 5K RPM.
I've noticed that all the starlets and glanza's have A242E - E means that this is an electronic controlled, but there are different versions of those gearboxes depending on the year! By the way the Gearbox was specifically designed for our cars and Toyota didn't use it on other cars!
Rev what Year is your car???
Rev what Year is your car???[/QUOTE]
As far as I can tell 1992 EP82 engine but I'm using a manual 1992-1994 ECU uncapped boost, speed limiter etc. with rev limit set at 7500.
Yes it is a A242E --- Can you confirm what axle you have? - It says 712 but that is a 5efhe auto axle number I am still not sure?
As far as I can tell 1992 EP82 engine but I'm using a manual 1992-1994 ECU uncapped boost, speed limiter etc. with rev limit set at 7500.
Yes it is a A242E --- Can you confirm what axle you have? - It says 712 but that is a 5efhe auto axle number I am still not sure?
Last edited:
Mine is Ep91 - and 1998 model (which is not just a facelift - like everyone says, the engine is the same, but the electronics is different!)
It says 242E - 05A
The radiator also cools the gearbox and the actual radiator is double thickness of the Manual Glanza Radiator!
Mine has no rev limit - I've done 8500 RPM once, also the speed limited has been taken off, goes over 112 mph!
0-60 are all different to every car and driver, you can't predict it unless you really go out to a drag strip and do many run down the track.
Too many variables:
Car's power (the all too spoken BHP and torque)
Car's wheels + tyres
Fuel loading
Road condition (dry/wet/moist)
Ambient temperature
Car's load (amount of unwanted stuff inside - eg spare wheel and passenger
)
Driver's weight
etc etc...
Modifying those variables in the 0-60 run, it will change your result.
Have a 40kg driver and a 120kg driver to drive the same starlet. It WILL be different.
Too many variables:
Car's power (the all too spoken BHP and torque)
Car's wheels + tyres
Fuel loading
Road condition (dry/wet/moist)
Ambient temperature
Car's load (amount of unwanted stuff inside - eg spare wheel and passenger
)Driver's weight
etc etc...
Modifying those variables in the 0-60 run, it will change your result.
Have a 40kg driver and a 120kg driver to drive the same starlet. It WILL be different.
0-60 are all different to every car and driver, you can't predict it unless you really go out to a drag strip and do many run down the track.
Too many variables:
Car's power (the all too spoken BHP and torque)
Car's wheels + tyres
Fuel loading
Road condition (dry/wet/moist)
Ambient temperature
Car's load (amount of unwanted stuff inside - eg spare wheel and passenger
Driver's weight
etc etc...
Modifying those variables in the 0-60 run, it will change your result.
Have a 40kg driver and a 120kg driver to drive the same starlet. It WILL be different.
I just want to know the AVERAGE - what people had in the past on their starlets with CT9 running at 1 bar! My current setup does 0-60 in around 8 sec or even more! Pretty standard Glanza!
churcherj
Member +
why dont u just go and try it? seriously there isnt an "average" as said it depends on so many things.
glanza bout 7 seconds
gt bout 6 seconds
ep85 bout 5 seconds
i asked toyota about these estimates and they comfirmed i am 100% correct, end of
Running 1 BAR on CT9???