has any ever ran or tried to run this setup?

[ragz]

i know what

go for a chargecooler petes made 1 it'll do the job plus would be nice to see a chargecooler fitted to a starbo let alone a tdo4 set up

 

[Nwimie]

charge cooler would be sweet :]

but the guy already has a tmic from a rx7 i think aslong as it was sheilded which isnt hard to do and it had some water spray jets also very easy mod it would be fine once rolling but not great around town and slow traffic etc.

just my view

 

[Phil]

i know what

go for a chargecooler petes made 1 it'll do the job plus would be nice to see a chargecooler fitted to a starbo let alone a tdo4 set up

well thanks everyone for their comments and opinions, much appreciated.
all i can say is "i'm thinking"

 

[Monkfish]

A chargecooler is a route I'm thinking about going down if I stick with the CT9...

 

[Phil]

A chargecooler is a route I'm thinking about going down if I stick with the CT9...

where would u be thinkin of getting one>? and who makes them?

 

[Monkfish]

where would u be thinkin of getting one>? and who makes them?

I was thinking about trying the cooler from the ST205 GT-4, although it may be too big to fit under the bonnet...

 

[Phil]

I was thinking about trying the cooler from the ST205 GT-4, although it may be too big to fit under the bonnet...

excuse my ignorance but is that a charge cooler?
i still thinkin of some way of heat sheilding the undershield of the Rx7 topmount and mayb spraying the bottom inch in heat resistant paint, and then spraying the whole thing matt black and putting the turbo sticky strip back on it? think i saw some1 do it before, with the mention heatshield arrangement.
anyway next job is finding some1 with the samco bends i need to fit it straight, then grind off the brakets.

 

[Phil]

*without the mentioned* sp

 

[TurboDave]

I am not too clued up on the td04 but I am sure I read somewhere before that the turbos compressor discharge (where the comressed air comes out) is underneath the turbo so you would need to route lots of pipework back up to use a tmic.

I may well be wrong though anyone with the answer?

 

[Monkfish]

A chargecooler is a route I'm thinking about going down if I stick with the CT9...

where would u be thinkin of getting one>? and who makes them?

I was thinking about trying the cooler from the ST205 GT-4, although it may be too big to fit under the bonnet...

excuse my ignorance but is that a charge cooler?...

I think you've lost track of the convo :homer:

 

[Phil]

yes yes sorry monkfish, i was gettin confused. how big is the cooler from the ST205 gt4?
very thick i take it?

 

[Monkfish]

yes yes sorry monkfish, i was gettin confused. how big is the cooler from the ST205 gt4?
very thick i take it?

Thickness, it's about the same as the stock TMIC I think, but don't quote me on that. Not sure about actual dimensions though...