Put a set in my mates EP91 on Sunday, had to switch the earth with dipped beam, when you flick over to full beam they flicker out, but when you run them off of a battery source (Wire up ballast to battery) it works without fault!
It uses two bulbs one is HID one is a standard Full beam bulb.
I had a little probe around with the multimeter and found the dipped has continuity between earth, and some other weird reading however I forget what they were!
When the original bulbs are inserted they work without fault! Also noticed now HID's are in the full beam light on the dash no longer works!
Any help wouyld be much appreciated!
It uses two bulbs one is HID one is a standard Full beam bulb.
I had a little probe around with the multimeter and found the dipped has continuity between earth, and some other weird reading however I forget what they were!
When the original bulbs are inserted they work without fault! Also noticed now HID's are in the full beam light on the dash no longer works!
Any help wouyld be much appreciated!