Glanza-Chris
Fresh Recruit
have the glanza sitting at standard boost atm , how do i adjust the actuator to run more boost ?
how to adjust boost on hks actuator ?
- Thread starter Glanza-Chris
- Start date
Texx
Super Moderator
Remove the retaining clip and disconnect the end of the attachment rod (C) from the wastegate arm.
Loosen the lock nut (B).
Shorten the actuator rod length by turning the attachment rod (C) clockwise.
Tighten the lock nut (B).
Reconnect the end of the attachment rod (C) to the wastegate arm and reinstall the retaining clip.
*Note: at no point should the actuator rod (A) be turned, this could lead to permanent damage to the actuator diaphragm.
To increase peak boost - shorten the arm
To reduce peak boost - lengthen the arm
Achieving the desired peak boost pressure is trial and error, so leave the retaining clip off of the wastegate arm until the turbo is boosting at what you want it to.
Loosen the lock nut (B).
Shorten the actuator rod length by turning the attachment rod (C) clockwise.
Tighten the lock nut (B).
Reconnect the end of the attachment rod (C) to the wastegate arm and reinstall the retaining clip.
*Note: at no point should the actuator rod (A) be turned, this could lead to permanent damage to the actuator diaphragm.
To increase peak boost - shorten the arm
To reduce peak boost - lengthen the arm
Achieving the desired peak boost pressure is trial and error, so leave the retaining clip off of the wastegate arm until the turbo is boosting at what you want it to.
Glanza-Chris
Fresh Recruit
Thanks mate .. What's the maximum boost I can run on ct9 with no fcd
